Tools You Will Need:
Power Drill with #2 Phillips Bit
Pencil or Pen
Sharp Utility Knife and Speed Square
Tape Measure
All the tools required are common tools, and Installation Instructions are printable from our Website above. These instructions are step-by-step and will guide you through the successful completion of your Bunk Wrap project. The instructions are based on the 2x4 kit, but will work for all Caliber Bunk Wrap Kit Sizes.
Bunk Slick products such as this are specifically intended to increase the ease of unloading and loading your boat, however, Caliber BunkWrap is designed for raw aluminum boats, pontoons, and any watercraft boat lift. BunkWrap is not designed, or recommended, for trailers for gel-coat, fiberglass, or painted aluminum hull boats.
This kit includes:
(1) 24ft Piece of Bunk Wrap for 2 x 6
(4) Bunk Wrap Ends for 2 x 6
(33) Stainless Steel #10 Truss Head Screws
(16) Stainless Steel Screw #8 Flat Head Screws
Features:
-Easier Loading and Unloading Compared to Carpet
-Longer Lasting Bunk cover; no need for frequent replacing
-Hardware is included
-Installs over Bare Wood Bunks, not over already carpeted boards
-Helps reduce the spread of invasive species
