This painted steel trailer axle features a 70 inch hub face, with a 75 inch overall measurement. With a 2000lb maximum capacity, this axle can accommodate both 4 Lug and 5 Lug hubs with the proper wheel bearings. This 1 3/4" round trailer axle mounts to your trailers leaf springs using u bolts and a leaf spring plate. We have multiple options of Leaf Spring U-Bolt Kits to choose from for mounting your axle and springs together. Depending upon your trailers needs, we offer Trailer Hubs and Trailer Bearing Protectors to complete your axle assembly.
-Includes Axle beam with spindles welded into the beam
-Painted Steel Axle Beam
-EZ Lube Greasing System. Grease the fitting on the tip of the spindle, grease exits through the rear port inside the grease seal, forcing old grease out, and new grease in.
-Includes Spindle Washer, Castle Nut, and Cotter Key
-No Brake Flange
-Spring Seats are welded onto axle beam at 58" on center. See below for spring seat measurements
- Made of 1 3/4" round steel tubing
-Straight Spindle uses 1 1/16"(44649) x 1 1/16"(44649) Wheel Bearings
-Grease Seal Size 1 1/2" ID
-Hub Face: 70 inches
Hub Face is measured from the outside of one hubface, to the outside of the opposite hubface. Another common term for hub face is axle track.
-Overall Length (tip to tip): 75 inches
-Spring Seat Measurement: Will accommodate 58" Leaf Spring Center
The leaf spring center or spring seat refers to the measurement of your trailers leaf spring position in relation to your frame and as it mounts to the axle. This is determined by measuring from the center of one leaf spring, across the axle to the center of the other leaf spring. So center of driver side leaf spring, to the center of the passenger side leaf spring. Your leaf spring measurement must fall inside the above measurements in order to properly work with this axle length. Dexter has determined the acceptable ranges to ensure the proper rating of your axle, and the available room on the axle to mount leaf springs.