This 16-foot flexible rubber DOT brake hose is a corrosion-resistant and reliable component for your single or tandem axle boat trailer's braking system. This boat trailer brake hose is UV-rated to withstand saltwater and sun exposure without deteriorating so it is perfect for boat trailers, as it is ready to perform well in corrosive marine environments. The brake line has two 3/16 inch male inverted flare brass fittings that use 3/8" - 24 threading, compatible with most trailer calipers, solenoid valves, and drum brake wheel cylinders. This hose is commonly seen on smaller single axle or tandem axle boat trailers, where it will run from the solenoid valve or electric over hydraulic actuator at the tongue of your trailer down across the frame to a
Brass Boat Trailer Brake Cross Fitting or
Brass Trailer Brake T-Fitting, where it will then run across either side of the axle to provide fluid to your calipers or drum brake backing plates and jump over to the next braked axle if necessary.
This brake hose provides great, reliable performance, as it is able to efficiently pump brake fluid to your trailer brake components in harsh conditions without wearing out prematurely. This replacement hose is ideal for your boat trailer if you have deteriorated rubber or corroded metal brake lines that you need to replace. The hose is high-pressure rated for trailer disc or drum brakes and is compatible with trailers that use electric over hydraulic actuators or surge couplers. The brass male inverted ends swivel to allow for easier attachment to your fittings without twisting the line around or kinking up. If you need a new mainline to run from your surge coupler or electric over hydraulic actuator, whether it's due to corroded or deteriorated old hoses or to replace a hose that is too long, this could be the perfect solution for your boat trailer!
Features
- DOT Approved Flexible Rubber Brake Hose
- 16' Long Hose
- UV Resistant Rubber
- 3/16" Male inverted Flare Ends
- 3/8"-24 Thread Size
