This is an Aluminum Fender Step Pad is designed for use with a Round Trailer Fender, and it has an Angled Side to match the Curvature of a Round Fender. Step pads like these are used to attach fenders and add a step surface to better access your boat trailer, utility trailer, or any other trailer.
The Aluminum Trailer Fender Step is 15 1/2" long, 4" wide, and 2" in Height. It features a textured finish on top for added grip and stability when used as a step. Typically a trailer would have 2 of these mounting brackets per Fender, and 4 total. This listing is for the Boat Trailer Fender Step Pad only, if you are adding these Fender Mounts to your Trailer for the first time you might like our Aluminum Boat Trailer Round Fender Mounts With Caps, which is a combo that includes a pair of this same Fender Step as well as 2 x 4 rubber caps to give the Trailer Fender Steps a completed and clean look.
There are no Pre-Drilled Holes on this Bracket, so you can easily install this to your Aluminum I Beam Trailer and its Fenders wherever needed. You can choose to either bolt these directly through your I Beam or C Channel, or if your trailer has a full square tubing frame, you can drill holes in the Bracket to allow for a U Bolt installation over your Trailer Frame instead.
Features:
- Aluminum Construction
- 15 1/2" x 4" x 2"
- No Pre-drilled holes
- Bolt On Installation
